Our refrigerator is well made and highly rated except that perhaps the manufacturer's engineering B-team designed the freezer door handle. A very long hard plastic handle, sufficiently rigid is set horizontally with two metal clips fastened by two screws to the metal door body. The handle is affixed by moving it right to left with the metal clips on each end sliding to the matching clips at the door face. Well, the poor design unraveled quickly early on with the handle detaching itself from the door. I would re-attach it but would only last for a while. Finally, I decided I would replace the handle and make it a woodworking project.
 |
| The handle outlived its usefulness |
A sliding mechanism still makes sense, using channels at both ends of the handle to match to two rails fastened by metal screws to the door face. Next photos make the concept a lot more clear.
 |
| It will be a more robust sliding mechanism |
 |
| The sliding mechanism is taking shape. |
 |
| Left end channel of the handle sliding into the rail. |
 |
| I attached the rail temporarily to a long scrap piece to test the fit of the sliding mechanism, adjusting several times with sand paper |
 |
| Although friction will sufficiently keep the channel and rail system in place, short screws will make it more secure and since they will be at the bottom they will be hidden from view. |
 |
| The handle has C-channels at both ends that will slide into the T-rails |
 |
| The rails are fastened very securely with a total of four screws. |
 |
| Note the handle partially sliding into the rail |
 |
| I could have painted the handle white to match the refrigerator's color but I think the wood grain of the walnut and oak provides a little warmth as a conversation piece. |
No comments:
Post a Comment